Groupdiy - groupdiy.com - GroupDIY
General Information:
Latest News:
Re: Poor Man's Pultec EQP1-A Build Support Thread 27 Aug 2013 | 08:57 pm
Quote from: duantro on August 26, 2013, 12:38:06 PM I'm assuming that this switch diagram is the current one? I found it in the drawing board thread. I'm getting signal to the High boost side (T1 and...
Re: [BUILD] 1176LN Rev D DIY 27 Aug 2013 | 08:52 pm
Quote from: kiopo on August 14, 2013, 07:20:48 PM Hello everyone, I got my potentiometers today (thank you Mike!) and finished my build, all working great . Calibration wasn't as awkward as I expect...
Re: EQ ONE and MICPRE ONE by Total Audio Control 27 Aug 2013 | 08:45 pm
Geile Teile ! i am jealous...i have to finish to many other projects and make one more 511 rack with new powerstation..i will end with the usual 2 more 511 racks with dual power i think wait..did no....
Re: source for cost effective mic preamp input transformers 27 Aug 2013 | 08:37 pm
Well if there is no electrostatic shield, then think of the transformer as a coupling capacitor (which with a path to ground on the secondary side is a high pass filter). So that part explains the ri...
Oscillate me Not! 27 Aug 2013 | 08:26 pm
Im building a second La2a point to point, since my last one went so swimmingly... I finished the build, being the second time around, i made the wires even neater than before, powered the unit on an....
Re: Audio Precision System One 27 Aug 2013 | 06:12 am
Super-late response, but APIB is a parallel bus. You can connect items in any order. Cable length has never been a problem for me, but I have always bought cables from AP. As for the catastrophic fai...
Re: [BUILD] Dual VPR & 51x Floor Box PSU Official Support Thread 27 Aug 2013 | 06:11 am
So I removed the seal pads and hardware as Jeff suggested, then bent each positive Regulator forward and fired my PSU back up. Everything worked smooth...I got the lights and all the voltages and most...
Re: Hammond Tonewheel generator substitute? 27 Aug 2013 | 06:08 am
Wow, that sounds great! I might want one of those as a separate instrument.
Re: [BUILD] VP28~500 Series~2-Stage Preamp~Official Support Thread 27 Aug 2013 | 06:03 am
So the 2 pre's match now? I thought they did not match. If they are the same I would say to proceed and install the opamps.
Re: Hammond Tonewheel generator substitute? 27 Aug 2013 | 05:54 am
Have you looked at the HOAX? http://www.keyboardpartner.de/hammond/hoax_en.htm
