Cpgnation - cpgnation.com - CPG Nation
General Information:
Latest News:
Goes lean at WOT 27 Aug 2013 | 08:18 pm
Got one for you guys. I have the EZ setup on my stack injection intake. The car runs great except when I floor it. From any rpm at any speed in any gear at any fuel level, it does the same thing. When...
EZ IAC adjustment very sensative 26 Aug 2013 | 04:15 am
Wondering if there might be a TPS or IAC issue, as I adjust the throttle blades I can open them slow till the IAC reads the min of 5, from that point I only have close them about 1/100th of a turn and...
Newbie needs help tuning 26 Aug 2013 | 03:08 am
OK, I am new here and new to EFI. I have a 72 Vette with a 383 and the EZ-EFI multiport system. I was lucky enough to have a trusted local speed shop use my car as a donor car for an install. I paid f...
A/F issue. 26 Aug 2013 | 01:09 am
When cruising on the highway actual A/F is 11.xx and target A/F is 13.20. I took fuel out of the VE cells affected and it ran smoother.....for a while. It gradually started running a bit rougher again...
Watch The World's End Online | Download The World's End Movie 26 Aug 2013 | 12:01 am
Watch The World’s End Online, The analogy could’ve jointly applied to the film itself, that comes loaded with expectation as a result of the long-awaited nearer of the unofficial three Flavours Cornet...
splitting the tach signal mutiple times 25 Aug 2013 | 09:34 pm
I searched but did not find what I was looking for. I currently run a FAST EZ EFI on my 71' Dodge Dart. The system has been great so far. followed the instruction to a T and had no problem. Car uses a...
Timing Settings 25 Aug 2013 | 07:58 am
I have a 1966 Corvette SB with Comp Cam part number 12-422-8 grind CS XR270HR-10 Hydraulic lifters. XTREME Energy Hydraulic Rooler Cam. Can someone provide a range of timing setting that can be used? ...
No power to fuel pump. 24 Aug 2013 | 11:07 pm
I have the FAST 3012350-05E EZ- EFI multiport kit. It was installed professionally by a speed shop and ran fine. That was right after I was transferred to Italy, so I have no idea what the wiring look...
COMP Cams® Engine Builder Duel To Be Held At Goodguys Lonestar Natioanls 24 Aug 2013 | 01:52 am
Memphis, TN – In October, the popular COMP Cams® Engine Builder Duel will make its first appearance at the Goodguys Lone Star Nationals in Fort Worth, TX to complete its run across the Southeastern Un...
Noisy lifters 23 Aug 2013 | 07:36 pm
I install 15956-16 lifters in a LSX block short travel race type The installation is 1/4 of a turn preload . when we start the engine all lifters click for a minute. I have try 0 +1/4 0+ 3/8 nothing...
